A very common question that is very easy to answer and should have been answered in your design phase of your home.
By Murray Wennerlund published 2-8-2023 updated 3-16-2023
|
|
|
|
A very common question that is very easy to answer and should have been answered in your design phase of your home.
By Murray Wennerlund published 2-8-2023 updated 3-16-2023
Make a contribution
| ePub
| Print
| Smoke Alarm
| 113 views
Need a manufactured home quote?
If you need a quote for a new manufactured home for the Louisiana Restore program send a note with your old VIN number and your status in the program. All we can do is help you get the quotes for the MHU you are looking to replace. Contact me
With more people building homes more energy efficient we have to expand our reading to be able to correctly design homes that provide the best overall energy saving experience. Heating, Cooling and Moisture control will be our main focus in this article.
By Murray Wennerlund published 1-24-2023 updated 3-16-2023
Make a contribution
| ePub
| Mobi
| Print
| thermal envelope
| 91 views
When I design a wall I always look at how the wall transfers the weight from above then I look at the openings and how I can make them easier to work with when choosing windows and doors. If you know the width, you know header so place it under top plate
By Murray Wennerlund published 1-18-2023 updated 3-17-2023
Make a contribution
| Mobi
| Print
| Door Header
| 129 views
Louisiana Water System Grades
Preliminary Report Card. Click your parish from the map. Some data will be updated May 2023.
When your worker is new and you are just not ready to let them go until you try a little training. I used to get the boot up the rear threat which meant to look, focus, learn how to do it like the carpenter would do it.
By Murray Wennerlund published 1-16-2023 updated 3-17-2023
Make a contribution
| Print
| Training
| 92 views
Hole saws are not always a one size fits all old-work boxes. Before you go drilling 6in holes make sure you do not need a 6 3/8in. Make the holes perfect so you do not use a tube of caulk to seal the gaps.
By Murray Wennerlund published 1-16-2023 updated 3-17-2023
Make a contribution
| Print
| Electrical
| 383 views
Carpenters and Carpenter helpers.
I am asked often if I would do carpentry work in my area. I'm getting too slow to actually handle most of the jobs I'm asked to do. I'd like to handoff the work to a carpenter that's better than me. I'm always looking for a good carpenter helper for projects I take on. Contact me and get listed and working.
When you are working with unvented or have a sealed roof design their are a few set rules in the IRC 2015 that need to be reviewed. After your code is covered we monitor our actual heat and humidity levels to prevent roof shingle and deck damage.
By Murray Wennerlund published 1-15-2023 updated 1-15-2023
Make a contribution
| Print
| Insulation
| 96 views
Labor brokers in most cases are individuals that have any number of laborers available to them to start or jump into a project.
By Murray Wennerlund published 9-29-2022 updated 9-29-2022
Make a contribution
|
| 210 views
Federal Disaster Assistance
When you are navigating the federal disaster assistance agencies your first stop should be to the TruckAndTools.Com Disaster Resources. Every disaster agency uses the same process but not every disaster agency follows strict policy and guidance. Don't go into your disaster recovery with blind trust of your federal and state agencies that are leading the push to get you sheltered and out of the program.
Many times your fastener schedule isnt complete or may actually be missing from your design prints. Its up to the homeowner to make sure every fastener used in your build is what the industry calls for and meets or exceeds code requirements.
By Murray Wennerlund published 9-26-2022 updated 9-26-2022
Make a contribution
| Print
| Fastener
| 91 views
You must become a member of TruckAndTools.Com, make a post sharing what needs to be repaired then add to your post as you complete your repairs the how, who, what, when and where of it all.
By Murray Wennerlund published 9-10-2022 updated 9-10-2022
Make a contribution
| Print
| Projects
| 119 views
Subscribe to TruckAndTools.Com on Google News
Read full articles from TruckAndTools.Com and explore endless topics, magazines and more on your phone or tablet with Google News. TruckAndTools.Com - Google News.
Or add our TruckAndTools.Com RSS feed to your favorite news reader and keep up when new information is shared.
When your contractor forgets to give you insurance information you may not be able to make warranty claims against the contractor you hired. This is part of the "Shoddy" work public awareness in preparation for the home repairs 2020 and 2021.
By Murray Wennerlund published 8-24-2022 updated 8-24-2022
Make a contribution
| Print
| Shoddy
| 126 views